NX Electrical Rounting - 2d formboard drawing change connection

asked in General Forum by (120 points)

Hi everyone, 

I'm working on 2D formboard drawing generated from a 3D model, but i don't have the 3D model file.

Is it possible to change a connection from one component to another, using the component wizard?

The error i have is "path not found", both for autoroute and manual route: how can i set a path?

If i try to create a linear part then i get anthor error and a "memory access violation"

0
commented by (120 points)
Thanks in advance

Please log in or register to answer this question.

1 Answer

0 votes
answered by (9.8k points)
Do you have the license to use Electrical Routing? The Author error might be because of no license...
The picture you have uploaded is too small. I cannot make anything out of it.
Welcome to SiemensNX.com
Share a new topic or ask a question.

558 questions

401 answers

143 comments

34.4k users

Nijiworks
...