NX 7.5: I want to change reference set "Entire part" to reference set "S" using journal.

asked in General Forum by (150 points)
Hi

I am new to NX 7.5
I want to change reference set "Entire part" to reference set "S" using journal. Please help me in regarding.

Thanks in Advance

Regards,

SaM

Please log in or register to answer this question.

1 Answer

0 votes
answered by (9.8k points)
Hi SaM...

It is not possible to change the name of the standard reference sets.
You can create a new one however...

Just start recording a journal where you perform the actions to create it.
Make sure that in your journal actions you also make all layers selectable so you are sure you can select everything in your partfile using ctrl-A.
Welcome to SiemensNX.com
Share a new topic or ask a question.

567 questions

404 answers

147 comments

57.3k users

Nijiworks

...