Siemens NX Assembly Drag Problem

asked in General Forum by (120 points)

Hi,

I can't "drag" parts "free" in the assembly module as my mouse's left click. I can move only with the "Move Componenet" command. It's not free. Where is the problem? I use NX 8.5.

Please log in or register to answer this question.

1 Answer

0 votes
answered by (9.8k points)
That is normal behaviour. You are of course only able to move components while in "Constraint mode" or when using the Move command.

In constraint mode it is just a matter of "grabbing" a face and then you will be able to move the component within the degrees of freedom.
Welcome to SiemensNX.com
Share a new topic or ask a question.

527 questions

396 answers

140 comments

22.5k users

Nijiworks
...